FORS TP8327 User Manual download pdf (Page 15)

Programme end

Clean the filter and drain the

water container after each

drying cycle. (See chapter CARE

AND CLEANING.)

If the drying cycle is completed, the symbol

flashes on the display. If the Buzzer

(Signal) option is on, the acoustic signal

sounds intermittently for 1 minute.

If you do not turn off the

appliance, the crease guard

phase starts. Laundry can be

removed during this phase.

To remove the laundry:

1. Push the On/Off (Ein/Aus) button for 2

seconds to turn off the appliance.

2. Open the appliance door.

3. Remove the laundry.

4. Close the appliance door.

HINTS AND TIPS

Ecological hints

• Spin good the laundry before drying.

• Use the load volumes which are

specified in the programme chart.

• Clean the filter after each drying cycle.

• Do not use fabric softener to wash and

then dry. In the tumble dryer laundry

becomes soft automatically.

• Use the condensate as distilled water,

e.g. for steam ironing. If it is necessary

clean the condensate before (e.g. with a

coffee filter) to remove possible small

pieces of fluff.

• Always keep the airflow slots on the

bottom of the appliance clear.

• Make sure that is good airflow in the

appliance installation position.

Adjustment of the remaining

laundry moisture degree

To change the default degree of the

remaining moisture of the laundry:

1.

Turn on the appliance.

2.

Wait approximately 8 seconds.

3. Select 1 of available programmes.

4. Push at the same time and hold down

the Anti-crease (Knitterschutz) and

Time Dry (Zeitwahl) buttons.

One of the symbols goes into the view on

the display:

- the maximum dry laundry

- the more dry laundry

- the standard dry laundry

5. Push the Start/Pause button again

and again until you set necessary

degree.

6. To memorise the setting, push at the

same time the Anti-crease

(Knitterschutz) and Time Dry

(Zeitwahl) buttons for approximately 2

seconds.

Deactivating the Water

container (Behälter) indicator

1.

Turn on the appliance.

2.

Wait approximately 8 seconds.

3.

Select 1 of available programmes.

4.

Push at the same time and hold down

the Anti-crease (Knitterschutz) and

Delay Start (Zeitvorwahl) buttons.

One of 2 configurations is possible:

• the Water container (Behälter)

indicator: is on and the symbol

goes into the view - the

water container indicator is

permanently on

• the Water container (Behälter)

indicator: is off and the symbol

goes into the view - the

water container indicator is

permanently off

15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Comments to this Manuals

No comments