FORS TP8327 User Manual download pdf (Page 14)

The drying time you see is

related to the load of 5 kg for

cotton and jeans programmes.

For the other programmes the

drying time is related to the

recommended loads. The drying

time of the cotton and jeans

programmes with the load more

than 5 kg is longer.

Options

Together with the programme you can set

1 or more special options.

To

activate or deactivate the option push the

applicable button .

When the option is activated the LED above

the button or symbol on the display comes

into the view.

Child lock option

The child lock can be set to prevent the

children to play with the appliance. The

child lock option locks all push buttons and

the programme dial (this option does not

lock On/Off (Ein/Aus) button).

You can activate the child lock option:

• before you push the Start/Pause button

- the appliance cannot start

• after you push the Start/Pause button -

programmes and option selection is off.

Child lock option activation:

1. Turn on the dryer.

2. Wait approximately 8 seconds.

3. Select 1 of the available programmes.

4. Push at the same time and hold down

the Time Dry (Zeitwahl) and Delay

Start (Zeitvorwahl) buttons .

The symbol comes into the view on the

display.

5. To deactivate the child lock, push again

the above buttons until the symbol goes

out of the view.

Buzzer (Signal) option

When the buzzer option is activated you

can hear the sound at the:

• cycle end

• anti-crease phase start and end

• cycle interruption

The buzzer option is by default always on.

You can use this option to activate or

deactivate the sound.

You can activate the Buzzer

(Signal) option with all

programmes.

To activate/deactivate the Buzzer

(Signal) option:

Push at the same time and hold down the

Anti-crease (Knitterschutz) and Time

Save (Zeit Sparen) buttons.

The acoustic signal sounds to confirm the

change.

Starting a programme

To start the programme:

Push

the Start/Pause button.

The appliance starts and the LED above the

button does not flash but is stable.

Programme change

To change a programme:

1. Turn the programme dial to Stop

position.

2. Set a new programme.

14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Comments to this Manuals

No comments