FORS AST8W User Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 48
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
Do not run the appliance without a filter. Clean the lint filter
before or after each use.
Do not dry unwashed items in the tumble dryer.
Items that have been soiled with substances such as
cooking oil, acetone, alcohol, petrol, kerosene, spot
removers, turpentine, waxes and wax removers should be
washed in hot water with an extra amount of detergent
before being dried in the tumble dryer.
Items such as foam rubber (latex foam), shower caps,
waterproof textiles, rubber backed articles and clothes or
pillows fitted with foam rubber pads should not be dried in
the tumble dryer.
Fabric softeners, or similar products, should be used as
specified by the fabric softener instructions.
Remove all objects from pockets such as lighters and
matches.
Never stop a tumble dryer before the end of the drying cycle
unless all items are quickly removed and spread out so that
the heat is dissipated.
The final part of a tumble dryer cycle occurs without heat
(cool down cycle) to ensure that the items are left at a
temperature that ensures that the items will not be
damaged.
Before maintenance, deactivate the appliance and
disconnect the mains plug from the mains socket.
SAFETY INSTRUCTIONS
Installation
Remove all the packaging.
Do not install or use a damaged
appliance.
Obey the installation instruction supplied
with the appliance.
Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves.
Do not install or use the appliance where
the temperature is less than 5°C or
higher than 35°C.
Make sure that the floor where you
install the appliance is flat, stable, heat
resistant and clean.
Make sure that there is air circulation
between the appliance and the floor.
Always move the appliance vertically.
The rear surface of the appliance must
be put against the wall.
When the appliance is put in its
permanent position, check if it is fully
level with the aid of a spirit level. If it is
not, adjust the feet until it is.
4
Page view 3
1 2 3 4 5 6 7 8 9 ... 47 48

Comments to this Manuals

No comments