FORS TA5500 User Manual download pdf (Page 11)

ENGLISH

Operating sequence

Before using your tumble dryer for the first time, we

recommend to place a few damp cloths inside the

appliance and dry for 30 minutes.

There may be dust inside a brand new tumble dryer.

Drying

1. Connect the appliance.

2. Open the door.

3. Load the items one at a time, shaking them out

loosely.

4. Close the door. Please check the laundry does

not get caught between the door and filter.

5. Press the ON/OFF button “EIN/AUS”: the mains-

ON light comes on.

6. Select the drying programme or time.

7. If required, press the low temperature button

“SCHON” and/or the buzzer OFF button

“SIGNAL AUS” .

8. Press the Start button START/PAUSE for 2

seconds: light “TROCKNEN” comes on and

drying starts.

The drum turns alternately in both directions

during drying.

All drying programmes end with a 10 minute

cooling phase (light “ABKÜHLUNG” is on).

You may remove the laundry after this phase.

9. If the laundry is not removed at the end of the

cycle, the dryer performs an anti-creasing phase

(duration: 30 minutes maximum).

The buzzer sounds every 10 seconds (if the

“SIGNAL AUS” button has not been pressed).

Lights “ENDE” and “KNITTERSCHUTZ” flash

alternately.

If you do not remove the laundry, the dryer will

stop automatically at the end of the anti-creasing

phase.

Light “ENDE” flashes and the mains-ON light

stays on.

P1108

P1104

Turn the programme selector dial to “AUS”; light

“ENDE” goes out.

Release the ON/OFF button (the mains-ON light

goes out) and immediately remove the laundry.

After each use

• Turn the programme selector dial to “AUS”.

• Switch the appliance off by releasing the ON/OFF

button “EIN/AUS . The mains-ON light goes out.

• Clean the filters (see page 14).

Important!

If the drying programme has to be stopped before it

reaches the end, we recommend that you turn the

programme selector dial to position “ABKÜHLUNG”

(cooling) and wait until the end of this phase before

removing the laundry. This will avoid a build-up of

heat inside the appliance.

Modifying the programme

To change a programme which is running, first

cancel it by turning the programme selector dial to

“AUS”. Select the new programme and press the

Start button “START/PAUSE .

125980310.qxp 2004-06-17 08:10 Page 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments

FORS TA5500 User Manual Page 11

Comments to this Manuals

Related products and manuals for Tumble dryers FORS TA5500