FORS WA9469 User Manual download pdf (Page 20)

Changing the delay start after

the countdown has started

To change the delay start:

1. Touch the Start/Pause button to pause

the appliance. The related indicator

flashes.

2. Touch the Delay Start button

repeatedly until the display shows the

desired delay time.

3. Touch the Start/Pause button again to

start the new countdown.

The ProSense load detection

The programme duration in the

display is referred to a

medium/high load.

After touching the Start/Pause button, the

maximum declared load indicator goes off,

the indicator flashes, the ProSense

starts the laundry load detection:

1. The appliance detects the load in the

first 30 seconds: the indicator and

the time dots flash, the drum rotates

shortly.

2. At the end of the load detection, the

indicator goes off and the time dots

stop flashing. The programme

duration will be adjusted accordingly

and could increase or decrease. After

further 30 seconds, the water filling

starts.

At the end of the load detection, in case

of drum overload, the indicator

is

flashing in the display:

In this case, for 30 seconds, it is possible

to pause the appliance and remove the

exceeding garments.

Once removed the exceeding garments,

touch the Start/Pause button to start the

programme again. The ProSense phase

can be repeated up to three times (see

point 1).

Important! If the laundry amount will not

be reduced, the washing programme

starts anyway, despite the overload. In

this case, it will be not possible to

guarantee the best washing results.

About 20 minutes after the

programme start, the

programme duration could be

adjusted again depending on

the capacity of water

absorption of the fabrics.

The ProSense detection is

carried out with complete

washing programmes only (no

skipping phase selected).

Programme phase indicators

When the programme starts the indicator

of the running phase flashes and the other

phase indicators are steady on.

E.g. the washing or pre wash phase is

running:

.

When the phase ends the relevant

indicator stops flashing and is steady on.

The next phase indicator starts flashing.

E.g. the rinse phase is running:

.

During the washing cycle, the appliance

mixes the detergent, the stain removal for

fabric treatment and/or the fabric softener

with water before introducing them into the

drum; the indicator

MIX

appears and

disappears on the display according to the

different programme phases (the arrows

flash alternatively).

If you select the Plus Steam the steam

phase indicators come on.

The steam phase is running: .

The anti-crease phase is running: .

20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 75 76

Comments to this Manuals

No comments