FORS WA1651 User Manual download pdf (Page 40)

3. Set the hose correctly by loosening the ring nut. After positioning the inlet

hose, be sure to tighten the ring nut again to prevent leaks.

4. Connect the hose to a tap with a 3/4” thread.

Always use the hose supplied with the

appliance.

Installation should comply with local water

authority and building regulations requirements.

Check the minimum water pressure required for

safe operation of the appliance in the chapter

“Technical Data”.

If you cannot make the cold water connection direct from the rising mains, you

may be able to operate the appliance from your cold water storage system. There

should be a minimum distance of between the appliance’s inlet and the bottom of

the water storage tank.

Water-stop device

The inlet hose is provided with a water stop device,

which protects against damage caused by water leaks

in the hose which could develop due to natural ageing

of the hose. This fault is shown by a red sector in the

window “A”. Should this occur, turn the water tap off

and refer to your Service Centre to replace the hose.

Water drainage

The end of the drain hose can be positioned in three

ways:

Hooked over the edge of a sink using the

plastic hose guide supplied with the machine.

In this case, make sure the end cannot come

unhooked when the machine is emptying.

This could be done by tying it to the tap with a piece

of string or attaching it to the wall.

In a sink drain pipe branch. This branch must be above the trap so that the bend

is at least 60 cm above the ground.

Directly into a drain pipe at a height of not less than 60 cm and not more

than 90 cm.

The end of the drain hose must always be ventilated, i.e. the inside diameter of

the drain pipe must be larger than the outside diameter of the drain hose.

The drain hose must not be kinked.

Installation

352

132962060.qxd 23/05/2008 9.48 Pagina 40

1 2 ... 35 36 37 38 39 40 41 42 43 44

No comments

FORS WA1651 User Manual Page 40